#GLOCK 30274 EJECTOR SERIES#
It's not a lot of money and they should not HURT the pistol's performance. Glock Ejector Replacement Part 30274 MaGlock Ejector Problems for the Gen 4 series seems to have been corrected by Glock’s new ejector replacement part. Hell need to take the ejector out of a Gen 4 ejector housing and. That seems to be a fix for a lot of folks. If there is anything in the process that is not quite right then you are left with extractors like mine - they were "chewed the Hell up" at the 500 round mark.īefore the APEX kit was available I tried to increase extractor tension and there was a noticeable improvement but the pistol(s) were probably 1 failure to feed in 60 rounds and the ejection was all over the place with one coming in hot and fast right into my face once every 60 rounds. I would recommend he try a 30274 ejector first. The extractor design does not lend itself to MIM as does a design with less geometry changes, tight radii, etc. Aftermarket Glock parts and Glock accessories by Ghost Inc triggers, connectors, baseplates. It was surprising to see the new ejector installed as I had assumed the gun would be returned with an 'in spec' prognoses and no parts changed, requiring a second trip back to Smyrna. GLOCK OEM GLOCK 30275 GEN4 9mm Trigger Housing by Ghost Inc. Now I cannot vouch that this will work on 100% of Gen4 and Gen3 pistols but it has stopped the erratic ejection on five (5) of five (5) thus far.īeing an mechanical engineer I observed the following: Surprisingly, the pistol came back in less than 10 days with ALL internals replaced and the new Gen4 30274 ejector installed. 5 models 17 19 19X 26 34 45 Ejector Fix Glock 9mm trigger housing 30274 Results Buy Glock 19 Gen 5 MOS.
Glock OEM Trigger Housing Fits Gen 3 w Polished Ejector 30274 Ejection fix. Now I have a 30274 Ejector on Gen 3 Glock 19.
I also replace the standard spring loaded bearing for the non-LCI spring Loaded Bearing (it's a little longer which gives more preload on the extractor). Glock Ejector 30274 OEM Replacement Ejection Fix fits 9mm 17 19 26 34.
#GLOCK 30274 EJECTOR INSTALL#
Then install the APEX Failure Resistant Extractor. The Apex Failure Resistant Extractor for Glock pistols is designed with a more robust extractor claw and utilizes Apexs proprietary. I suspect it has to due with the numerous government contracts Glock has and the cost of updating older models already on the street. (2) insure you have the latest recoil spring assembly - or the equivalent if you wish to run a SS guide rod. Why the 17 and 19 gen 5 still ship and are still specified to have the 30274 ejector, along with the gen 3 still having the 336 ejector is a bit of a mystery. One thing that I have found to work on a total of five (5) pistols is the following:
0 kommentar(er)
